Quick Start Guide

ManualsBrandsBest Buy essentials ManualsCell Phone Accessories3.6 A USB Charger Wall Outlet - White

Features

• Replaces a standard duplex outlet

• Quickly charges USB devices

• Tamper-resistant outlets for added safety

• Provides two USB ports with 3.6A total output

• Provides two standard 110V power outlets

• Works in nearly all installations

• Compatible with your existing decora wall plate

We recommend that you use a professional

electrician to install the USB charger wall outlet. For

information about electrical specications, see

Specications.

Safety

Warnings:

• RISK OF ELECTRIC SHOCK — Use only in dry

locations and only indoors.

• All cables should be routed away from the charger

outlet openings.

• DO NOT use with any aquarium equipment.

• DO NOT install in an outlet that is not grounded.

Notes to the installer:

• This device must be installed in accordance with

National and Local electrical codes.

• To prevent severe shock or electrocution, always

turn power OFF at the service panel before

working with wiring.

• This device should be used with copper or

copper-clad wire. DO NOT use with aluminum

wire.

• DO NOT plug this device into a shallow wall box.

The wall box must be deep enough to house the

charger outlet. If the box is too shallow, the

charger outlet will not t securely into the wall.

Installing the charger

Warning: DISCONNECT POWER. Failure to

do so can result in severe injury or death.

1 Make sure that you disconnect power to the

circuit by removing the fuse from the circuit

breaker or turning OFF the circuit breaker.

2 Remove the wall plate and mounting screws

that cover the old outlet.

3 Carefully remove the existing outlet from the

wall box.

4 Disconnect the wiring from the old outlet. Note

the wire positions. Connect the charger outlet

wires the same way.

5 Connect the wires to the charger outlet:

• Black lead attaches to the hot wire(s)

• White lead attaches to the neutral wire(s)

• Green lead attaches to the ground wire(s)

Electrical outlets

USB ports

Hot (black)

Neutral (white)

Ground (green)

Before using your new product, please read these instructions to prevent any damage.

Package contents

• 3.6A USB Charger Wall Outlet

• White decora-style wall plate

• Screws: 2 long and 2 short

• Quick Setup Guide

3.6A USB Charger

Wall Outlet

Quick Setup Guide

BE-HW36A218

BE-HW36A218_21-0048_QSG_V1_EN_Final.ai 1 2/10/2021 9:37:30 AM

Summary of content (2 pages)

PAGE 1
3.6A USB Charger Wall Outlet Quick Setup Guide BE-HW36A218 Features • • • • • • • Replaces a standard duplex outlet Quickly charges USB devices Tamper-resistant outlets for added safety Provides two USB ports with 3.6A total output Provides two standard 110V power outlets Works in nearly all installations Compatible with your existing decora wall plate USB ports Before using your new product, please read these instructions to prevent any damage. Package contents • • • • 3.
PAGE 2
Insert the straightened wire into either of the two holes of the hot and neutral locations on the side of the outlet. Power passes between the two corresponding holes for pass-thru wiring. Attach the ground wire to the bottom of the outlet. Tighten every screw and make sure that no bare copper wire is exposed. When tightening screws, use 14 pounds-per-inch of torque. 7 Carefully insert the charger outlet into the wall box. 8 Secure the charger outlet to the wall box with the two long screws (provided).