Quick Start Guide
Refrigerator
Filter
Quick Setup Guide
BE-LGLT1000P531
Package contents
• Refrigerator water lter
• Quick Setup Guide
Compatibility
Compatible with the following
branded lters:
LG®
LT1000P, LT1000PC, LT1000PCS,
LT- 1000PC, ADQ74793501,
MDJ64844601, ADQ747935,
ADQ76793501
Kenmore®
46-9980, 9980, ADQ74793502
Features
• NSF 42 and 53 certied to lter contaminants, including chlorine, cysts, lead,
mercury, carbofuran, benzene, and endrin
• Lasts up to six months or 200 gallons (757 L)
• Eliminates cloudiness for fresh, clear drinking water
Installing your water lter
1 Shut o the water supply, then turn o the water shuto valve on your refrigerator.
Locate the lter holder in your refrigerator.
7 Turn on the water supply and run water through the dispenser for about ve
minutes at 0.5 gpm (about 2.5 gallons or 9.5 L) to remove any trapped air and clear
the system.
CAUTION: This lter should not be used with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
8 Open the refrigerator door and make sure that no water leaks from the new lter.
Note: If leaks occur, repeat the installation steps. If leaks persist, discontinue use and call
customer service.
WARNING: To reduce the risk of property damage due to water leakage, this lter MUST be
installed in accordance with the manufacturer's specications and instructions. This lter unit
must be replaced every 200 gallons (757 L) or six months. Failure to follow instructions and
operating specications will void your warranty. Further, the manufacturer assumes no
responsibility or liability for damages arising out of misuse of the product.
Side door lter:
2 Lift up and remove the lower bin
door.
3 Swing the right end of the old lter
out of the compartment and then
hold and rotate the lter
counterclockwise to remove it from
the lter head.
4 Insert the new lter into the lter
head and rotate it clockwise.
5 Swing the lter back into the
compartment.
6 Replace the lower bin door.
Upper corner lter:
2 To open the lter cover, push in
where indicated and the cover will
drop down.
3 Remove the old lter by slowly
rotating it counterclockwise. A small
amount of water may drip down.
4 Insert the new lter into the water
lter holder.
5 Slowly turn the new lter clockwise
until it stops. The lter will click and
lock into place.
6 Close the lter cover.
OR
Before using your new product, please read
these instructions to prevent any damage.
Resetting your change
lter indicator
• LG: Press and hold the reset button
for three seconds. If this doesn’t
work, see the documentation that
came with your refrigerator.
• Kenmore: The lter reset for
Kenmore refrigerators varies by
model. See the documentation that
came with your refrigerator.
Storage and maintenance
• Replace your lter every six months
or two hundred gallons (757 L) to
prevent bacteria and fungus growth
in your lter, supply lines, and
storage tank.
• Stored lters do not expire. Keep
your unused lters in a cool, dark,
and dry place until you need them.
• If you do not use your water
dispenser for more than four days,
run two gallons (7.6 L) of water
before using it to prevent bad
tasting water.
• Make sure that the refrigerator door
is closed or the dispenser will not
work.