Quick Start Guide

ManualsBrandsBest Buy essentials ManualsAppliance Parts & AccessoriesNSF 42/53 Water Filter Replacement for Select Samsung Refrigerators - White

Installing your lter

• It is normal for black carbon particles to appear on the outside of your new

lter during shipping. Simply wipe them away before installation.

• This water lter is designed to prevent leaks. Twist in place securely to ensure a

proper t.

1 Twist the old lter a quarter-turn counterclockwise.

2 Pull the lter straight out and discard.

3 Carefully remove the plastic cap from the new lter before installation.

4 Push the new lter into the refrigerator until it stops.

5 Twist the lter a quarter-turn clockwise.

6 Make sure that the indicator arrows on the new lter are lined up with the

indicator arrow on the refrigerator after installation.

7 Run about two gallons (7.6 L) to three gallons (11.3L) of water through your

refrigerator’s water dispenser to remove air and loose carbon pieces. The water

may be cloudy and sputter until the air is removed.

8 Reset your “change lter” indicator (if your refrigerator has one). See below.

Before using your lter

If your refrigerator has a change lter indicator, reset it. See “Resetting your lter

indicator” for instructions.

Resetting your lter indicator

Note: These are the most common lter reset instructions. If the instructions don’t work for

your refrigerator brand, see the documentation that came with your refrigerator.

• Samsung®: Press and hold the ICE TYPE and CHILD LOCK buttons for three

seconds. The water lter indicator should turn green.

Note: Only hold these buttons for three seconds. Holding these buttons for ve seconds

cancels the reset. If you cancel the reset, repeat the procedure.

Storage and maintenance

• Replace your lter every three to six months to prevent bacteria and fungus

growth in your lter, supply lines, and storage tank.

• Stored lters do not expire. Keep your unused lters in a cool, dark, and dry

place until you need them.

• If you do not use your water dispenser for more than four days, run two gallons

(7.6 L) of water before using it to prevent bad tasting water.

Package contents

• Refrigerator water lter(s)

(1 or 2 pack)

• Quick Setup Guide

Compatibility

Samsung®

DA29-00020B, DA29-00020A,

DA2900020A, DA29-00019A,

DA2900019A, DA-97-08006A,

DA-97-08006A-B, DA-97-08006B,

DA97- 08006A-B, HAF-CIN,

HAF-CIN-EXP, HAF- CINEXP, HAFCIN

Kenmore®

04609101000, 09101, 46-9101, 469101,

9101

Before using your new product, please read

these instructions to prevent any damage.

Refrigerator

Filter

Quick Setup Guide

BE-SSHC531 / BE-SSHC532

Summary of content (2 pages)

PAGE 1
Refrigerator Filter Quick Setup Guide BE-SSHC531 / BE-SSHC532 Before using your new product, please read these instructions to prevent any damage. Installing your filter • It is normal for black carbon particles to appear on the outside of your new filter during shipping. Simply wipe them away before installation. • This water filter is designed to prevent leaks. Twist in place securely to ensure a proper fit. 1 Twist the old filter a quarter-turn counterclockwise.
PAGE 2
Troubleshooting Specifications My refrigerator is not dispensing water • Make sure that the filter is securely connected to the receiver. Do not use tools to tighten the filter in place. • Make sure that the water line to the refrigerator is turned on. The valve must be completely open for the refrigerator to receive water. • Make sure that the refrigerator door is closed or the dispenser will not work. My water dispenser is dripping • A few drops are normal.