BOSCARE Chuzhou Donlim Electrical Appliances CO., Ltd No.
IMPORTANT SAFEGUARDS To reduce the risk of fire, explosion, electric shock, or injury when using your ice maker, follow these important safety instructions: 1. Before using check that the voltage power corresponds to the one shown on the appliance nameplate. 2. Do not remove any safety, warning, or product information labels from your ice maker. 3. Plug the ice maker into an exclusive grounded power outlet. No other appliance should be plugged into the same outlet.
into the ice maker. 23. Never use the ice maker when there is flammable gas leakage. 24. Never store or use gas and other flammable articles near the ice maker to avoid any fire. 25. Unplug the ice maker before moving it to avoid damaging the refrigerating system. 26. Do not attempt to disassemble, repair, modify, or replace any part of your product. 27.
Key (with indicator) Function ON/OFF Start or stop the appliance ICE Standby mode: “ICE” indicator blinks; Working condition: “ICE” indicator lights solidly. ICE FULL “ICE FULL” indicator lights up when the ice basket is full. ADD WATER “ADD WATER” indicator lights up when the water reservoir is lack of water. S The indicator lights up when select small ice. L The indicator lights up when select large ice.
. The appliance must be placed on a dry and level surface with sufficient ventilation, far from heat sources such as ovens, heaters and corrosive gases.Leave about a 6-inch (15cm) clearance on all sides of the ice maker for proper ventilation. 6. Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to fill the water reservoir with water of room temperature or lower. 7. Do not use the appliance at a very cold environment (lower than 5℃). 8.
14.Suggest replacing the water every a week. Please empty the water reservoir if the ice maker is not used for a long time. CLEANING AND MAINTENANCE To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning your ice maker once per week. 1. Stop the ice-making cycle by pressing the “ON/OFF” key, unplug the ice maker from the wall outlet and allow it to warm up to room temperature. 2.
Problem Possible causes Solution 1.Low water level or lack of water 2.The water screen at the bottom of water reservoir is blocked. Pump malfunction. 1.Stop making ice, refill water and then press “ON/OFF” key to restart ice-making cycle. 2.Do cleaning Send it to the authorized department for repair. “ICE FULL” indicator lights up 1.Ice basket is full and the infrared light is blocked by the ice. 2. Infrared light-emitting diode & light-receiving diode do not work 1. Remove the ice from ice basket.
TECHNICAL PARAMETERS Model: IM2100DT-UL Electrical Rating: AMPS 1.7A 120V AC 60Hz Refrigerant: R600a/0.8oz Design Pressure : High Side :290Psig Low Side :138 Psig Minimun Installation Clearance Top 6.0 IN BACK 6.0 IN Sides 6.