Owner Manual

14.Suggest replacing the water every a week. Please
empty the water reservoir if the ice maker is not used for
a long time.
To keep your ice tasting fresh and your ice maker looking
great, we recommend cleaning your ice maker once per
week.
1. Stop the ice-making cycle by pressing the “ON/OFF”
key, unplug the ice maker from the wall outlet and allow it
to warm up to room temperature.
2. If residual water is found in the ice tray, gently push
the ice tray back so that all water drains into the water
reservoir.
3. Move the appliance forward to a place 60mm away
from the working table and open the drain plug to drain
out excess water (see Fig.4, Fig.5 and Fig.6).
4. Check and make sure the drain plug must be closed
well. Fill the water reservoir with clean water, press‘SE-
LECT’until the ‘CLEAN’ indicator flashes,then press the
“ON/OFF” key , the pump will start to pump water and
keep running for 6 minutes, and it will enter into standby
condition after running for 6 minutes, finally, open the
drain plug and empty the water.
5. Remove the ice basket.
6. Clean the ice maker interior with a soft cloth soaked
with warm water and vinegar, then rinse with clean water
and then drain all the water.
7. Replace the drain plug well in position. Wash the ice
8. Clean the exterior of the ice maker with a soft damp
cloth. Use a mild dishwashing soap, if necessary.
NOTE:
1)Do not use organic solvent, boiled water, detergent,
strong acid and strong alkali etc. for cleaning.
2)Do not clean the evaporator.
9. Please empty the water reservoir and dry it for storage
if the ice maker is not used for a long time.
CLEANING AND MAINTENANCE
Fig.4
Fig.5 Fig.6