Service manual

2
CHASSIS LIFTING BEAM
See next page for chassis beam diagram and specifications.
If it is desired to raise a vehicle by the frame, this can be done by using optional chassis lifting
beams. The chassis lift beam fits into the cradle where the tire would normally fit and spans
between a pair of posts. The beam comes with lifting pads and height adapters that slide and
stack along the beam to accommodate the frame pick up points.
Directions for Use:
Drive vehicle into bay.
Roll chassis beam under desired end of vehicle where frame pick points are.
Slide pads to desired positions and stack adapters as desired to accommodate frame pick points.
Roll posts to each end of chassis beam, cradling ends of chassis beam with forks.
Lift pair until chassis beam contacts frame.
Verify proper frame engagement.
Check other posts for proper engagement of tires or frame (depending on if another chassis beam
is used or the other end is lifted by tires)
Operate lift as desired.
NOTICE:
The chassis beam is rated for 35,000 lbs total.
Always ensure that the beams are cradled in the forks as close as possible to the carriages. (Do
not place beams on tips of forks) Also, ensure that vehicle is centered on chassis beam to ensure
even loading of beam and posts.
This beam is intended to be used in conjunction with another beam or another set of mobile
column posts to lift the entire vehicle. Do not use this beam to pick up just one end of a vehicle
only. Load beam only on lifting pads, do not load beam on center.
This beam is intended for use on Mohawk MP-Series 15” Long Fork lifts ONLY.
Refer to the ANSI standard “Vehicle Lift Points for Service Garage Lifting,” ANSI/SAE J2184-
Oct92, safety manual “Lifting if Right,” ALI/SM01, and “Vehicle Lifting Points Guide”
ALI/LP-Guide for proper positioning of vehicles on lift.