Service manual

4
WING PLOW ADAPTERS
See next page for wing plow adapter diagram and specifications.
The wing plow adapters are to be used when it is desired to raise a vehicle with side wing plows
or RV’s with side extensions where the forks are not able to get close to the tires. The wing plow
adapters are used with a pair of posts to enable lifting of the whole front axles of a vehicle by the
tires.
Directions for Use:
Drive vehicle into bay.
Roll wing plow adapters around each side of front axle tires (center tires on beam lengths).
Roll posts to each end of adapters, inserting forks fully into adapter sockets.
Lift pair until wing plow adapters engaged tires.
Verify proper engagement.
Check other posts for proper engagement of tires.
Operate lift as desired.
NOTICE:
The wing plow adapters are rated for 25,000 lbs total (per pair of beams, see spec on next page)
Always ensure that the wing plow adapters are fully inserted over the lifting forks. Also, ensure
that vehicle is centered on the wing plow adapters to ensure even loading of beams and posts.
These adapters are intended to be used in conjunction with another set of mobile column posts to
lift the entire vehicle. Do not use these to pick up just one end of a vehicle only. These adapters
are designed to lift only tires and must not be top loaded. Do not use these to pick up vehicles by
frames. Use adapters only in pairs. These adapters must not be single loaded.
The wing plow adapters are intended for use on Mohawk MP-Series 15” Long Fork lifts ONLY.