Service manual

12
LIFT FINAL CHECKOUT (AFTER INSTALLATION):
REV (9/1/2012)
THIS PROCEDURE OUTLINES THE FINAL CHECKS TO MAKE AFTER INITIAL INSTALLATION OF THE LIFT UNIT.
REPEAT THIS PROCEDURE IF THE LIFT IS RELOCATED.
AFTER THE LIFT IS FULLY ASSEMBLED, RAISE THE LIFT EMPTY A FEW TIMES TO VERIFY:
 PROPER POWER INPUT TO ALL POSTS (NOT APPLICABLE TO DC COLUMNS)
 PROPER COMMUNICATION OF ALL POSTS IN SYSTEM
 POST RECOGNITION OF ALL POSTS IN SYSTEM
 ALL POSTS RAISING SMOOTHLY AND ALL SYNCHRONIZED
 NO LEAKS PRESENT AT ANY FITTING JUNCTIONS
 LOCKS ARE ENGAGING ON ALL POSTS SIMULTANEOUSLY AS LIFT IS RAISING
 LOCKS ARE DIS-ENGAGING ON ALL POSTS WHEN LOWERING BUTTON DEPRESSED.
 LOCKS ARE RE-ENGAGING AFTER DIS-ENGAGED.
 LIFT IS NOT DRIFTING DOWN WHEN RAISED (RAISE LIFT, THEN STOP, AND VERIFY DRIFT DOWN OF CYLINDERS)
 NO VIBRATIONS FROM LOOSE CLAMPING, ETC.
ONCE THIS IS COMPLETE, LOCATE A REPRESENTATIVE VEHICLE INTO THE LIFTING AREA.
USE A VEHICLE THAT WEIGHS AT LEAST 50 PERCENT OF THE CAPACITY OF THE LIFT.
OBSERVING LIFTING PROCEDURES CONTAINED IN THIS MANUAL TO POSITION THE VEHICLE ONTO THE LIFT.
RAISE LIFT APPROXIMATELY 1 FOOT. VERIFY THE FOLLOWING:
 ALL POSTS RAISING SMOOTHLY AND ALL SYNCHRONIZED
 NO LEAKS PRESENT AT ANY FITTING JUNCTIONS
 LOCKS ARE ENGAGING ON ALL POSTS SIMULTANEOUSLY AS LIFT IS RAISING (SOME VARIANCE EXPECTED)
 LIFT IS NOT DRIFTING DOWN WHEN RAISED (RAISE LIFT, THEN STOP, AND VERIFY DRIFT DOWN OF CYLINDERS)
 NO VIBRATIONS FROM LOOSE CLAMPING, ETC.
PRESS PARK. VERIFY THE FOLLOWING:
 ALL POSTS LOWERING ONTO LOCKS
RAISE LIFT A FEW INCHES, THEM PRESS LOWER. VERIFY THE FOLLOWING:
 ALL POSTS LOWERING SMOOTHLY AND ALL SYNCHRONIZED
 NO LEAKS PRESENT AT ANY FITTING JUNCTIONS
 NO VIBRATIONS FROM LOOSE CLAMPING, ETC.
 LOCKS ARE NOT RE-ENGAGING WHILE LOWERING
RAISE LIFT TO FULL STROKE. VERIFY THE FOLLOWING:
 ALL POSTS RAISING SMOOTHLY AND ALL SYNCHRONIZED
 NO LEAKS PRESENT AT ANY FITTING JUNCTIONS
 LOCKS ARE ENGAGING ON ALL POSTS SIMULTANEOUSLY AS LIFT IS RAISING (SOME VARIANCE EXPECTED)
 LIFT IS NOT DRIFTING DOWN WHEN RAISED (RAISE LIFT, THEN STOP, AND VERIFY DRIFT DOWN OF CYLINDERS)
 NO VIBRATIONS FROM LOOSE CLAMPING, ETC.
LOWER LIFT ONTO LOCKS. VERIFY THE FOLLOWING:
 ALL LOCKS ARE ENGAGING UPON DESCENT
 PROPER SYNCHRONIZATION OF TRACKS
RAISE LIFT 3 INCHES, THEN LOWER VEHICLE TO FLOOR. VERIFY THE FOLLOWING:
 ALL POSTS LOWERING SMOOTHLY AND ALL SYNCHRONIZED
 NO LEAKS PRESENT AT ANY FITTING JUNCTIONS
 NO VIBRATIONS FROM LOOSE CLAMPING, ETC.
 LOCKS ARE NOT RE-ENGAGING WHILE LOWERING
ENSURE THAT ALL MANUALS AND OTHER INSTRUCTIONAL MATERIALS ARE DELIVERED TO OWNER/USER/EMPLOYER.
ENSURE THAT USERS ARE INSTRUCTED IN THE SAFE AND PROPER USER OF THE LIFT.
THIS ENDS THE FINAL CHECKOUT OF LIFT.
File: Final Checkout MP-Series.doc