Service manual

Comms Lost Error:

This screen appears if any column in the system is lost after it was

previously present. This could be due to a column being turned off

or if the communications to the post are not connected. The post in

which communications is lost will be identified on the screen. All

controls will be locked-out until this is remedied.

i.e. The display to the left shows loss of communications to post 3.

E-Stop Error:

If any post in the system has an Emergency Stop button pushed, this

screen will appear showing which post was stopped. All controls

will be locked-out until this is remedied.

i.e. The display to the left shows the emergency stop button pushed

on post 2.

Lift at Max Height Error:

Indicates that a post has raised to the maximum height setting (set

in the factory setting menu). The post that has reached this height

will be identified. Raising and parking are not allowed in this

situation, only lowering. (Note that the max height setting is

adjustable for buildings with low clearance, etc..)

i.e. The display to the left shows that post 4 has reached max

height.