Service manual

31
Jack Operation:
Prior to moving
posts, the rear
jack wheels must
be engaged. To
do this, push black
lever down, then
jack handle to
desired height.
When post is
in position,
collapse jack
wheel fully by pulling
black lever up.
Jack Relief Adjustment:
If jack does not
collapse under
load or if jack does
not raise back of post
onto wheel, then the
relief valve may need
to be adjusted. To set
proper jack capacity, lift
empty post with jack,
then remove relief port cap
with 5mm allen wrench (see
location to right). Using
5mm allen wrench SLOWLY
turn adjustment screw counter-
clockwise until jack collapses.
Then screw in clockwise
1 full turn. Replace port cap.