Service manual

STARTING OR DEEP-CYCLE – EV – TROLLING MOTOR – WHEELCHAIR
U1 8AU1 2,38,39,Y 10 20 54 98 200 340 110 75 60 50 39 23 16
8AU1H 2,17,38,39,Y 10 20 54 98 200 340 110 75 60 50 39 23 16
22NF 8A22NF 2,38,39,G 22 40 102 180 365 620 160 120 95 80 62 35.5 28
24 8A24 2,17,38,39,G 35 60 150 280 550 900 220 165 130 110 85 50.5 36
8A24NH 2,38,39,G 35 60 150 280 550 900 220 165 130 110 85 50.5 36
27 8A27 2,17,38,39,G 43 75 185 330 640 1080 270 200 153 130 98 59 44
31 8A31DT 2,16,17,U 53 87.4 200 348 706 1265 305 226 174 147 114 68.2 49.0
4D 8A4D 2,17 106 180 413 745 1512 2507 508 408 318 266 200 115 85
8D 8A8D 2,17 138 230 517 953 1874 3040 600 475 386 325 256 151 106
GC2 8AGC2 2,G 94 171 409 718 1409 2304 ———————
PART
NO.
MINUTES DISCHARGED AT*
75
AMPS
GROUP
NO.
FOOTNOTES
50
AMPS
25
AMPS
15
AMPS
8
AMPS
5
AMPS
5
MINS.
DISCHARGE AMPS PER 12-VOLT BATTERY
TO 1.75 VPC @ 80°F (27°C)*
10
MINS.
15
MINS.
20
MINS.
30
MINS.
60
MINS.
90
MINS.
®
ABSORBED GLASS MAT SERIES
E.P.M. Form No. 0151 Rev. 5/10
© 2010 by EPM Printed in U.S.A.
Potential Applications of AGM
Starting, Lighting and Ignition
Cars • Trucks • Marine • Snowmobiles
Lawn & Garden Tractors
Traction
Wheelchairs • Floor Sweepers • Guided Vehicles
Small Fork Lifts • Trolling Motors
Industrial
Cable TV • Emergency Lighting • Exit Lighting
Alarm and Security Systems • PBX Systems • Utility Control
Switching Equipment • Medical Equipment
Recreational Vehicles • Electronic Cash Registers
Portable Devices
Construction Equipment • Portable Pumps and Generators
Portable Test and Measuring Equipment
Portable Tools • Mobile TV, VCR, VTR
STARTING OR DEEP-CYCLE – EV – TROLLING MOTOR – WHEELCHAIR
U1 8AU1 12 37.0 32.0 29.5 27.5 23.0 24.0 (10.9) 7
3
⁄4 (197) 5
1
⁄8 (130) 7
1
⁄4 (184)
8AU1H 12 37.0 32.0 29.5 27.5 23.0 24.0 (10.9) 8
5
⁄16 (211) 5
1
⁄8 (130) 7
1
⁄4 (184)
22NF 8A22NF 12 63.0 55.0 50.0 46.5 35.5 38.5 (17.5) 9
3
⁄8 (238) 5
1
⁄2 (140) 9
1
⁄4 (235)
24 8A24 12 91.0 79.0 72.0 69.2 50.5 53.0 (24.0) 10
7
⁄8 (276) 6
3
⁄4 (171) 9
7
⁄8 (251)
8A24NH 12 91.0 79.0 72.0 69.2 50.5 53.0 (24.0) 10
1
⁄4 (260) 6
3
⁄4 (171) 9
7
⁄8 (251)
27 8A27 12 100.0 92.0 84.0 78.0 59.0 63.0 (28.6) 12
3
⁄4 (324) 6
3
⁄4 (171) 9
7
⁄8 (251)
31 8A31DT 12 110.0 105.0 90.0 86.0 68.2 69.0 (31.3) 12
15
⁄16 (329) 6
3
⁄4 (171) 9
3
⁄8 (238)
4D 8A4D 12 210.0 198.2 176.0 164.0 115.0 129.0 (58.5) 20
3
⁄4 (527) 8
1
⁄2 (216) 10 (254)
8D 8A8D 12 250.0 245.0 212.0 197.0 151.1 158.0 (71.7) 20
3
⁄4 (527) 11 (279) 10 (254)
GC2 8AGC2 6 220.0 187.0 173.7 163.0 102.6 69.5 (32.0) 10
1
⁄4 (260) 7
1
⁄8 (181) 10
7
⁄8 (276)
PART
NO.
APPROX.
WEIGHT
LBS. (KGS.)
MAXIMUM OVERALL DIMENSIONS
INCHES (MM)
LENGTH
GROUP
NO.
V
O
L
T
S
WIDTH
HEIGHT
[%]
100
90
80
70
60
50
40
30
20
10
-30
-22
-20
-4
-10
14
0
32
+10
50
+20
68
+30
86
+40
104
+50
122
[°C]
[°F]
1xI
20
4xI
20
20xI
20
Percent of Available Capacity
Ambient Temperature
Shown are the changes in
capacity for a wider ambient
temperature range, giving
the available capacity as
a percentage of the rated
capacity at different ambient
temperatures, for three
different load examples,
with uninterrupted discharge
to the appropriate discharge
cut-off voltage. The values
for the upper edge of the
curve were obtained from
charging at an ambient
temperature of +20°C (68°F)
with a voltage limit of 2.3
V/cell. For the lower edge,
charging was carried out at
the specified ambient tem-
perature. The curves show
the behavior of the battery
after a number of cycles.
Constant Voltage vs. Temperature
Capacity vs. Operating Temperature
Shown is the
constant charging
voltage in relation
to the ambient
temperature for
cyclic and float use.
Warranty void if opened or improperly charged. Caution: Constant under- or overcharging will
damage any battery and shorten its life. Use a good constant potential, voltage-regulated charger.
For 12-volt batteries, charge to at least 14.4 volts but no more than 14.6 volts at 68°F (20°C).
For 6-volt batteries, charge to at least 7.2 volts but not more than 7.3 volts at 68°F (20°C). Do
not charge in a sealed container. The AGM Series has more capacity at high discharge rates than
conventional deep cycle batteries.
AMPERE HOUR CAPACITY*
100
HR.
20
HR.
8
HR.
All data subject to change without notice.
No part of this document may be copied or reproduced, electronically
or mechanically, without written permission from the company.
All batteries are manufactured in polypropylene cases.
✝ Excludes Group U1
FOOTNOTES:
2 - Black cover / Gray case
16 - Dual terminal universal design
17 - Includes handle
38 - “Non-Spillable” defined by DOT (Department of
Transportation) definition
39 - “Non-Spillable” defined by ICAO (International
Commercial Airline Organization) and IATA
(International Airline Transportation Association)
definitions
B - Flag terminal w/ 3/8" diameter hole
G - Offset post w/ horizontal hole, stainless steel 5/16"
bolt & hex nut
U -
Molded-in offset SAE post and vertical
5/16" NEG., 3/8" POS. stainless steel
studs & locking hex nuts
Y - Small L terminals with round holes
* Nominal
1
HR.
5
HR.
STANDARD/OPTIONAL
TERMINALS
Y
G
B
U