Specifications

•
t' 'rE5?tt
Specifying a
Trigger
Condition
To capture the data and then place the data of interest in the center
of the display of the TIMING WAVEFORMS menu, you need to ten
the logic analyzer when to trigger. Since the first event of interest IS
when the LRAS IS asserted cnegative-gmng edge of RAS), you need
to tell
the logic analyzer to tngger on a negative-going edge of the
RAS signal
Select the TIMING TRACE menu hy pressing the TRACE key.
2_ Set the trigger so that the logic analyzer triggers on the
negative-going edge of the RAS.
8_ Place the cursor on the Then find Edge field under the
lahel RAS, then press SELECT.
b. Place the cursor on the. (period! III the pop-up and press
SELECT once Pressing SELECT once in this pop-up
changes a period to I which indicates a negative-gomg edge
c, Place the cursor on Done and press SELECT_ The pop-up
doses and a $ will be located in this field. The $ indicates
an edge has been specified even though it can't be shown In
the HEX hase.
![IRArl TEST 1- TIMING TI'RCE 5PECIFURTIOfl
Lab e I c::PB:OCI8:0
ae 5 e ~c::B:L::J
FI no
p ettar n ~c:::z::::::J
•
e·
•
•
•
•
e.
•
•
•
Using the Timing Analyzer
5-8
men f1M •
Edge ~c=J
e.
I
•