User`s manual

D:\manual\UM_PCM-ULT\ML_Ult3k\661-UT3K-002-31.doc
KEVIN KU 第 23 頁 2003/3/4
A
PPENDIX B
S
PECIFICATIONS
Tower model 700VA 1000VA 1500VA 2000VA 3000VA
19" rack-mount model 700VA RM 1000VA RM 1500VA RM 2000VA RM 3000VA RM
Power Rating P.F.=0.7 700VA
490W
1KVA
700W
1.5KVA
1050W
2KVA
1400W
3KVA
2100W
Voltage 100V:76V-130V 110V:80V-138V 115V:83.5V-140V
120V:87V-140V
208V:152V-260V 220V:160V-276V 230V:167V-280V
240V:174V-280V
Frequency 50Hz or 60Hz
±
3Hz
Phase Single phase
AC Input
Power factor 0.98
Dc voltage 24V 36V 48V 72V 96V
Back-up Time Full Load 5min 7min 5min 9min 7min
Half Load 12min 20min 17min 20min 15min
Type Sealed lead acid battery, free maintenance
Protection Cut off without draining any current when battery low
Battery
Recharge time About 8 hours to 90% after fully discharged
Frequency 50Hz/60Hz (Auto detection)
Voltage 100/110/115/120V or 208/220/230/240V
Voltage regulation
±
2% (except 3000VA/110V
±
3%, 3000VA RM/110V
±
3%
Frequency stability
±
0.5%
Power factor 0.7 (lagging)
Harmonic distortion <3% of T.H.D. at linear load
Overload detection 105% for 10 seconds and 130%
±
10% for 300ms
AC output
Crest factor ratio 3:1
Efficiency AC to AC >85%
Power failure or
recovery
0ms Transfer
Overload disappear Auto transfer to UPS
Noise Level 1m. distance <45dBA <52dBA
Status line input (green), inverter output (green), bypass (yellow), fault
(red)
Battery capacity 4 green, 1 red LED and red bar LEDs indicated low capacity
LED
Indicators
Load level 4 green, 1 red LED and red bar LEDs indicated overload
capacity
Battery discharge The first warning will beep every 4 seconds to indicate battery in
use.
The second warning will beep every 1 second to signal battery
low condition.
Alarm
UPS fault Continuous beeping sound
19