Owner manual

10
English
! The appliance must be installed by a qualied person
in compliance with the instructions provided.
!
Wear gloves when carrying out installation and
maintenance operations.
AIR VENT
(for ducting versions)
! Prepare the hole and the air vent duct (150 mm dia-
meter).
! Use a duct of the minimum indispensible length.
! Use a duct with as few elbows as possible (maximum
elbow angle: 90°).
! Avoid drastic changes in the duct cross-section.
! Use a duct with an as smooth as possible inside.
! The duct must be made of certied material.
! Do not connect the hood to smoke exhaust ducts
for the products of combustion (boilers, replaces,
stoves, etc).
! For the air vents comply with the provisions laid down
by the competent authorities.
In addition, the air must not be evacuated through a
hole in the wall unless specically intended for this
purpose.
! Fit air intakes in the room to prevent the hood from
creating a negative pressure in the room (which must
not exceed 0.04 mbar); if the hood is used at the
same time as non-electrical equipment (gas-, oil- and
charcoal-red stoves, etc.) the exhaust gas may be
sucked in by the heat source.
Ducting version
The hood puries the air and evacuates it to the outside
through an exhaust duct (diameter 150 mm).
CONTROLS
P1
P2
P3 P4
1
P
P1: 5’ TIMER
P2: Filter alarm reset
P3: Motor off / speed decrease – .
- holding down the button, the motor turns off sto-
ring the current speed
P4: Motor on / speed increase
P5: Lights on/off
L1 Signalling crown:
- Hood in standby: lights up amber-orange. 30” after
the last key has been pressed the crown turns off
- Motor on: L1 lights up turquoise ashing. The
ashing frequency is proportional to the speed
- 5’ TIMER function : L1 lights up turquoise xed
- Filter alarm active: L1 lights up red xed (30h); L2
lights up red ashing (120h)
EN