Installation Guide

8. REMOVE THE KNOCK-OUT OPENING

From inside the power pack, remove the wiring cover by removing two (2) retaining

screws and set aside. Punch out the electrical knockout hole on top of the power pack.

Install the wire clamp (included in parts bag).

HR0027

9. INSTALL THE ADAPTER/DAMPER (CP34 AND CP35 MODELS)

Using (4) no. 8 x 3/8” screws from parts bag, assemble the adapter/damper on the top

of the power pack. To ensure proper opening of the dampers, remove shipping tape if

present. Seal all joints with metal foil duct tape to eliminate air leaks.

HJ0016

MOUNTING SCREW LOCATION

7. REMOVE THE BOTTOM PANEL

Using a Phillips screwdriver, remove both bottom panel

retaining screws and set aside.

Disassemble bottom panel from power pack and set aside.

HO0111

HO0110

RETAINING SCREW LOCATION

- 6 -

SIDE VIEW

6. REMOVE GREASE DRIP RAIL

A. Lift grease drip rail to disengage it from

the bottom panel.

B. Slide grease rail all the way to the left or

right (

) and lift the opposite end to

disengage the other end from the bottom

panel (

). Remove it from the power

pack and set aside for later use.

HD0291

HD0292