Installation Guide

- 9 -
14. REINSTALL THE BLOWER(S)
HD0282
RIGHT SIDE
MOUNTING SCREW
LOCATION
Using a 5/16” socket, secure the blower to
the inner top of the power pack with all blower
mounting screws (previously removed in
step 12).
HD0269
LEFT SIDE MOUNTING
SCREW LOCATION
Slide the blower to engage its flange in the
retaining bracket.
HD0293
CP34 AND CP35 MODELS
CP37 MODEL
For each blower, using a 5/16” socket, secure the blower to the inner top of the power pack
through the front and rear brackets with all blower mounting screws (previously removed
in step 12).
HD0297
For each blower, slide it to engage its flanges in both retaining brackets.
NOTE: Both blowers are identical and can be mounted on either side of the power pack.
BLOWERS FRONT BRACKET
BLOWERS REAR BRACKET
HD0298
13. INSTALL THE POWER PACK
Using provided no. 8 x 1/2” chrome plated screws, install the power pack inside
the custom hood. Start with 2 screws on front corners, then use 4 screws for
sides and use the remaining ones to finalize securing the front power pack. (See
figure beside for mounting screw specific locations.)
Make sure the adapter/damper (or the adapter) enters the ducting. When there
is access to the top of the power pack, seal connections with metal foil duct tape.
CAUTION
Take care not to kink ducting when installing the power pack.
HH0102A