Specifications Sheet

Page 2
PLANNING
CABINET CUTOUTS
!
CAUTION: BEFORE CUTTING HOLE IN
CABINET FOR DUCTWORK, check for
interference with floor joists, wall studs,
electrical wiring or plumbing.
Use the dimensions in illustrations to help plan how and where to
provide duct access through your cabinet. A 1-7/8" x 19" rectangular
duct can be used through left, right, floor and back of cabinet.
Also, 8" round or 10" round can be used through cabinet floor.
For left, right, or rear exhaust:
Allow at least 18" for transition and elbow or blower.
For left / right exhaust:
A 30" deep cabinet is recommended to align properly with flex
blower. Flex blower can be mounted to rear cabinet wall or to a
platform / frame (not provided) on the base of the cabinet floor.
(See flex blower instructions).
Cabinet depths of 24" to 30" are required - depending on the
type of cooking appliance.
Below, Side or Rear Ducting Cutouts
4"
(10.2 cm)
5-7/8"
(14.9 cm)
5-7/8
"
(14.9 cm)
5-7/8"
(14.9 cm)
21"
(53.3 cm)
21
"
(53.3
cm
)
21"
(53.3 cm)
Appliance
Cutout
2"
(5.1 cm)
1
-1/8"
(2.9 cm)
1
-
1/8
"
(2.9 cm)
1
-1/8"
(2.9 cm)
4"
(10.2 cm)
4"
(10.2 cm)
21"
(53.3 cm)
21"
(53.3 cm)
21"
(53.3
cm)
21
"
(5
3.3 cm)
21"
(53.3
cm)
24-3/4"
(62.9
cm)
24-3/4
"
(62.9 cm)
24-3/4"
(62.9
cm)
4"
(10.2 cm)
Flex Blower Ducting Cutout
5-5/8"
(14.3 cm)
5-5/8"
(14.3 cm)
1-1/2"
(3.8 cm)
Ø8"
(20.3 cm)
Appliance
Cutout
Center line of downdraft
7-5/8"
(19.4 cm)
7-5/8"
(19.4 cm)
Ø8"
(20.3 cm)
Appliance
Cutout
Center line of downdraft
Flex Blower Ducting – Remote Location Cutout
Dimensions based off of Model 432 - 8" round elbow
10" Exterior or In-line Blower Ducting Cutout
8-5/8
"
(21.9 cm)
8-5/8
"
(21.9 cm)
Ø10"
(25.4 cm)
Appliance
Cutout
Center line of downdraft
Dimensions based off of Model 418 - 10" round elbow