Specifications

ManualsBrandsBest ManualsHousehold AppliancesDD0148SS

Page 2

Downdraft Ventilators

AIR

VENT

COUNTER

TOP

BLOWER

BOX

CHIMNEY TOP

COOK TOP

GEAR

MOTOR

COVER

TYPICAL INSTALLATION

120 VAC

GROUNDED

OUTLET

This downdraft blower system

is designed to be used to ex-

haust airborne contaminants

when cooking with a variety of

gas or electric cooktops. It can

be mounted in island, penin-

sula, or conventional wall loca-

tions.

This unit can be easily installed

following these basic steps:

•

Cut out the countertop

opening.

•

Mount the unit in the

cabinet.

•

Connect the ductwork and

electrical.

•

Install the cooktop.

Note: the high level of air flow of

this appliance may effect the

gas flame on some types of gas

cooktops. This is NORMAL and

will cause no harm, but can be

corrected by lowering the speed

of the blower.

PLANNING

Interior Blower Installation

Exterior Blower Installation

Note: the high level of air flow of this appliance may effect the gas

flame on some types of gas cooktops. This is NORMAL and will

cause no harm, but can be corrected by lowering the speed of the

blower.

ELECTRICAL

SPECIFICATIONS

120 VAC • 60 Hz • 4.0 A

TAKE MEASUREMENTS

All Units

1. Refer to the cooktop installation instructions for dimensions of

cooktop, countertop cut-out, and cabinet requirements. Mod-

els DD0130SS & DDEX30SS will fit in most 30" wide cabinets.

Models DD0136SS & DDEX36SS will fit in most 36" wide

cabinets. Models DD0148SS & DDEX48SS will fit in most 48"

wide cabinets. However, it is recommended that oversized

cabinets be used for easier installation.

2. Cooktop depth can vary greatly from one to another. This may

cause the fit of these two appliances to be rather tight.

Pay special attention to the areas of potential interference high-

lighted above. A countertop with (A) a raised lip and/or (B) a

backsplash may not allow enough flat countertop for a proper

installation. Note that 2" of flat countertop is required behind

cooktop and that 1-3/4" is necessary between the back edge of

the cooktop and the inside of cabinet back.