Installation Manual

8. PREPARE HOOD (ALL MODELS) (CONT’D)

HJ0067

6. Measure the required length of 8" round metal duct from the adapter/damper

to the ductwork rough-in in the ceiling. Connect this section of duct to the

adapter/damper and seal joint with metal foil duct tape.

9. INSTALL HOOD

WARNING

BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.

CAUTION

DO NOT REMOVE the protective plastic film covering the decorative flue (upper and lower) and the hood yet.

HD0424

FRONT

HOUSE WIRING

1. Attach blower box assembly to lower angle brackets using 16 no. 10-32 x 1/2"

quadrex screws (4 per angle brackets). Connect hood duct to ceiling duct and

seal joint with metal foil duct tape.

NOTE: Ensure electrical channel is facing where the front of the hood will be

positioned.

2. Run house wiring through wire clamp into blower box electrical channel. Tighten

wire clamp to secure house wiring cable to blower box.

NOTE: The length between the top of the blower box and the bottom of the hood

is 12 3⁄16".

HD0565

SEAM