Installation Guide

FOR DUAL BLOWER UNIT, MAKE SURE THE IMPELLERS

ARE CORRECTLY INSTALLED, THE INSERT WILL NOT

WORK PROPERLY IF REVERSED.

Both impellers are different in the dual blower, one rotates

clockwise and the other counterclockwise. Each wheel and

motor have an arrow and a number on them, you have to

match them correctly (see drawing beside).

- 11 -

Secure the blower by installing 2 more no. 8 x 3/8” screws for the P5 blower and 4 more no. 8 x 3/8” screws for P8 into the locations shown in

the pictures below (single blower or dual blower). Reinstall impeller(s) and cover.

HD0080

HD0081

Single blower (P5)

18. INSTALL THE BLOWER (INTERIOR BLOWER) (CONT’D)

Install (4) no. 8 x 3/8” screws into the location as shown in the pictures below (single blower or dual blower). Do not tighten screws down

fully, leave a 1/8” gap. Hang blower unit onto blower plate (screws through the large part of the keyhole). Slide the blower to its position

(screws in the small part of the keyhole). Tighten the (4) screws.

HD0044

HD0045

Single blower (P5)

Dual blower (P8)

WARNING

Never plug the 2-prong blower cord to the 3-prong power supply cord.

Plug the power supply to the 3-prong male connector (A) and the blower unit into the

2-prong female receptacle (B) inside the insert.

HE0022

Dual blower (P8)

HD0023

FRONT

HD0023