Installation guide

INSERT MODEL NUMBER A
PIK33 32½”
PIK45 44½”
- 7 -
8. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet, using the
dimensions shown beside.
NOTES: 1. The notch shown in the inset must be cut only if the WCPI
optional remote control will be installed.
2. The recommended distance from the back to the rearmost
cutout edge is 2¼” minimum.
A
17 1/16''
HD0084A
3 1/2''
16 3/8''
2 1/4''
min.
6. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table below to find the
right liner model number for your insert and width of custom hood. To view specific model information, including depths for each
liner models, visit www.BestRangeHoods.com
or contact Technical support (phone number listed on page 14, in warranty text).
To install, see instruction packed with custom hood liner.
The liner must be installed before
the insert.
NOTE: On some liners models, front liner piece may overlap front insert flange. If so, remove the front liner piece, assemble
insert, and reassemble front liner piece.
LINER MODEL INSERT MODEL CUSTOM HOOD
NOMINAL WIDTH
L3336S PIK33 36”
L3342S PIK33 42”
L4548S PIK45 48”
L4554S PIK45 54”
L4560S PIK45 60”
HA0038A
The electrical connection for the remote control is located in front of the
insert. Perform this connection before the insert installation
.
For installation details, see installation instructions included with the
WCPI remote control.
7. INSTALL THE WCPI REMOTE CONTROL (OPTIONAL)
HL0044
9. INSTALL BLOWER (INTERIOR OR EXTERIOR BLOWER)
INTERIOR BLOWER : Follow all subsequent steps of this manual.
EXTERIOR BLOWER : Refer to instructions packed with exterior blower and follow steps 13, 14, 16, 17, 19 and up of this
manual.