PIK33 PIK45 Installation Guide 05862 REV-18

18. INSTALL THE BLOWER (INTERIOR BLOWER) (CONT’D)

Install 4 no. 8 x 3/8" screws into the location as shown in the pictures below (single blower or dual blower). Do not tighten screws down

fully, leave a 1/8" gap. Hang blower unit onto blower plate (screws through the large part of the keyhole). Slide the blower to its position

(screws in the small part of the keyhole). Tighten the 4 screws.

FOR DUAL BLOWER UNIT, MAKE SURE THE IMPELLERS

ARE CORRECTLY INSTALLED, THE INSERT WILL NOT

WORK PROPERLY IF REVERSED.

Both impellers are different in the dual blower, one rotates

clockwise and the other counterclockwise. Each wheel and

motor have an arrow and a number on them, you have to match

them correctly (see drawing at right).

HD0044 HD0045

Single blower (P5) Dual blower (P8)

Secure the blower by installing 2 more no. 8 x 3/8" screws for the P5 blower and 4 more no. 8 x 3/8" screws for P8 into the locations shown

in the pictures below (single blower or dual blower). Reinstall impeller(s) and cover.

HD0080 HD0081

Single blower (P5) Dual blower (P8)

HD0023

1 2

FRONT

WARNING

Never plug the 2-prong blower cord to the 3-prong power supply cord.

HE0022

Plug the power supply to the 3-prong male connector (A) and the blower unit into the 2-prong

female receptacle (B) inside the insert.