PIK33 PIK45 Installation Guide 05862 REV-18

7
6. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table below to find the right liner
model number for your insert and width of custom hood. To view specific model information, including depths for each liner models, visit
www.BestRangeHoods.com or contact Technical support (phone number listed on page 14, in warranty text).
To install, see instruction packed with custom hood liner.
The liner must be installed before the insert.
NOTE: On some liners models, front liner piece may overlap front insert flange. If so, remove the front liner piece, assemble insert, and
reassemble front liner piece.
7. INSTALL THE WCPI REMOTE CONTROL (OPTIONAL)
The electrical connection for the remote control is located in front of the
insert. Perform this connection before the insert installation.
For installation details, see installation instructions included with the WCPI
remote control.
8. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet, using the dimensions
shown at right.
HL0044
LINER MODEL INSERT MODEL CUSTOM HOOD NOMINAL WIDTH
L3336S PIK33 36"
L3342S PIK33 42"
L4548S PIK45 48"
L4554S PIK45 54"
L4560S PIK45 60"
HA0038A
INSERT MODEL NUMBER A
PIK33 32½"
PIK45 44½"
A
17 ¹/16”
HD0084A
3½”
16 ³/8”
2¼”
min.
NOTES: 1. The notch shown in the inset must be cut only if the WCPI optional
remote control will be installed.
2. The recommended distance from the back to the rearmost cutout
edge is 2¼" minimum.
9. INSTALL BLOWER (INTERIOR OR EXTERIOR BLOWER)
INTERIOR BLOWER : Follow all subsequent steps of this manual.
EXTERIOR BLOWER : Refer to instructions packed with exterior blower and follow steps 13, 14, 16, 17, 19 and up of this manual.