Instruction Manual

12
English
! The appliance must be installed by a qualified person in
compliance with the instructions provided.
!
Wear gloves when carrying out installation and
maintenance operations.
Filtering version
The hood purifies the air and recycles the clean air back
into the room. For this version, the following are required:
1 charcoal filter.
CONTROLS
Speed display
PU1: ON/OFF Lights
PU2: ON/OFF Motor 1
st
speed
PU3: ON/OFF Motor 2
nd
speed
PU4: ON/OFF Motor 3
rd
speed
PU5: ON/OFF Motor 4
th
speed
5’ timer function:
Pressing PU2, PU3 or PU4 for two seconds when the
motor is set to the corresponding speed, the 5’ timer
function is activated. The corresponding LED starts
blinking to display this function. After five minutes of
operation the motor is turned off. If you change the speed
while the timer is running, the function is NOT
deactivated. To deactivate the function, press the blinking
key for two seconds.
NOTE – the 5’ timer function can be activated for the
normal speeds only (1st, 2nd, 3rd)
Buzzer:
Each time the key is pressed, a beep is sounded.
Filter alarm:
After 30 hours of motor operation, the grease filter alarm
is activated (all the LEDs come on). The alarm is
activated when the motor is off and remains displayed for
30". To deactivate the alarm, press one of the keys for 2"
during alarm display. After 120 hours of motor operation,
the charcoal filter alarm is activated (all the LEDs blink).
The alarm is activated when the motor is off and remains
displayed for 30". To deactivate the alarm, press one of
the keys for 2" during alarm display.
MAINTENANCE
! Before cleaning or maintenance cut the power.
Cleaning the hood
WHEN TO CLEAN IT: clean it at least every 2 months to
prevent the risk of fire.
EXTERNAL CLEANING: use a cloth moistened in
lukewarm water and neutral detergent (for painted
hoods); use specific products for steel, copper or brass
hoods.
INTERNAL CLEANING: use a cloth (or brush) soaked in
denatured ethyl alcohol.
WHAT NOT TO DO: do not use abrasive or corrosive
products (e.g. metal sponges, brushes, too hard brushes,
very aggressive detergents, etc.)
Cleaning the grease filters
WHEN TO CLEAN IT: clean it at least every 2 months to
prevent the risk of fire.
HOW TO REMOVE THE FILTERS: push the catch near
the handle towards the rear of the hood and pull the filter
downwards
HOW TO CLEAN THE FILTERS: hand wash or in the
dishwasher using a neutral detergent. If washing in the
dishwasher, possible discoloration of the filters does not
in any way compromise their functioning.
Replacing the charcoal filter (P)
(for filtering version only)
WHEN TO REPLACE IT: replace it at least every 6
months.
HOW TO REMOVE IT: position the charcoal filter inside
the hood and fit the 2 filter clips (M)
GB