Installation manual

Mount the 8” round adapter/damper (included in a separate box) to the hood using
4 no. 8 x 3/8” sheet metal screws (included).
1. Align the hood and center it above the hood mounting bracket. Gently lower the hood until it securely engages the bracket.
2. Level the hood.
3. With the hood hanging in place, secure it to the wall through
both holes located in the inside upper back of hood using
2 no. 8 x 1½” screws.
4. Drill through both holes located in the inside lower back of
hood using a 3/16” drill bit. Insert the included drywall anchors
into the drilled holes (one for each hole). Secure the hood to
the wall using 2 no. 8 x 3/4” screws and 2 washers.
- 7 -
7. INSTALL THE HOOD
CAUTION
DO NOT REMOVE the protective plastic film covering the decorative flue (upper & lower) and the hood yet.
WARNING
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
!
HD0378A
LOWER HOLES LOCATION
SIDE VIEW
BACK OF THE HOOD
Ø 7/32” TYP.
U
PPER HOLES LOCATION
8. INSTALL ANKWT32 NON-DUCT KIT (NON-DUCTED INSTALLATION ONLY)
Refer to the installation sheet included with the non-duct kit for details.
Once the non-duct kit installation is done, go to step 13 to finalize the hood installation.
6. INSTALL UPPER FLUE MOUNTING BRACKET (DUCTED INSTALLATION ONLY)
Center the upper flue mounting bracket with the center line
previously drawn in step 5 and place it flush with the ceiling.
Use the upper flue mounting bracket as a template to mark the
position of its screws.
Drill the 3 screw holes using a 3/16” drill bit.
Insert the included drywall anchors into the drilled holes (one per
hole).
Secure the upper flue bracket to the wall using 3 no. 8 x 3/4”
screws.
Make sure that the bracket is tight against the wall.
HD0377
C
L
CEILING
SCREW LOCATIONS
MOUNTING BRACKET
FLUSH WITH CEILING
9. INSTALL ADAPTER/DAMPER (SINGLE BLOWER MODELS ONLY)
HJ0042