Specifications

Bluegiga Technologies Oy
Page 58 of 64
14 Certification Guidance for an End Product Using WT32i
14.1 Bluetooth End Product Listing
The Bluetooth SIG requires for every commercially available product implementing Bluetooth technology to be
listed on the Bluetooth SIG End Product Listing (EPL).
For the details on how to make the end product listin, please refer to the Bluetooth End Product Listing Guide
available in www.bluegiga.com.
14.2 CE Approval of an End-Product
When placing the CE logo to an end-product the manufacturer declares that the product is in conformity with
the requirements of the R&TTE directive. The minimum requirements for placing the CE logo to an end-
product are
 Declaration of Conformity signed by the manufacturer. The person who signs the DoC must be
traceable
 Generation of a technical construction file including
o Technical information about the product
o Test reports for all the relevant standards required to demonstrate that the product meets the
requirements of the R&TTE directive
The end-product manufacturer is fully responsible for the compliance of the end-product. The modules test
reports can partly be used to demonstrate the compliance but typically all the radiated tests must be re-tested
with the end product. All the conducted RF tests can be inherited from the modules test reports because the
conducted RF characteristics are not dependent on the installation of the module.
Standard
Description
Tested with
the module
Test required for
the end product
Modules test
results can be
inherited to the
end product test
report
EN 300 328
RF emissions
Module fully
tested
Radiated test cases
Yes (partly)
EN 301 489-1
EN 301 489-17
EMC immunity and
emissions
Only EM field
immunity tested
All the test cases
relevant for the end
product
No
EN 62479
Human exposure to
EM fields
Not tested. The
module is
compliant
without testing
because the TX
power is less
than 20 mW
Evaluation required
in case of multiple
radios in co-
location.
No
EN 60950
Safety
Not tested
because there
aren’t any test
cases that
would concern
the module
Full evaluation with
the end product
No
Table 23: CE standards summary for WT32i