Installation Manual

Rev. 3 0907
TrailMax™ II Sport Reclining High Back Bucket Seat – Installation Instructions
39434 / 39438 pg. 3
Before beginning the seat installation, set the parking
brake, place the vehicle in gear or park and chock the
wheels to reduce the risk of the vehicle unexpectedly
moving, which could result in serious injury.
The seat is designed to be installed on the original seat
riser. DO NOT remove or loosen any of the original
seat riser anchor bolts. Doing so may cause improper
anchoring of the seat, which could result in serious injury, to you and others.
Remove the four (4) nuts that mount the seat track
slides to the riser. Do not throw away the four (4) nuts
since they will be reused.
The nuts are under the ledge on the riser.
Then remove the bucket seat and track slides from the
vehicle (the seat riser will remain in the vehicle).
Remove the Existing Seat from the Vehicle
Seat Track Slide
Remove Nuts
Seat Track
Slide
Remove Nuts
Seat Riser - Remains
in vehicle
Track Bar
DO NOT reuse the original mounting bolts. Reuse of the
bolts could cause the seat to loosen, which could result in
loss of control of the vehicle, causing bodily injury to the
vehicle occupants and to others.
Remove Bolts
& Throw Away
Seat Cushion
(Front)
Track
Track Bar - Push
down to slide
Track forward
Lay the seat down with the bottom
side facing up. Push down on the
track bar to slide the track forward,
allowing access to the rear track
mounting bolts. Remove the bolts
and discard them.
Remove the Tracks
Track
Track Bar - Push
down to slide Track
toward rear
Push down on the track bar again to slide the track toward the rear of
the seat. Remove the front track mounting bolts and discard them.
Do not throw away the tracks, they will be mounted to the Bestop seat.
Remove Bolts
& Throw Away
Seat Cushion
(Front)
Remove the Tracks