User Guide

TrailMax™ II Sport Reclining High Back Bucket Seat – Installation Instructions
Your new Bestop seat has two (2) mounting holes on each side
of the front and three (3) holes on each side of the rear. This
allows tracks from various Jeep models to be used with the Be-
stop seat. Locate the correct mounting pattern by placing the
track on the seat and positioning the track so that the four holes
in the track align with four mounting holes in the seat, allowing
the track to be positioned in the center of the seat.
Track
Select front holes
in seat that best
center the track
on the seat
Seat Cushion
(Front)
Rear
Select rear holes in
seat that best center
the track on the seat
Hole Pattern
Use only the bolts provided in the Parts Kit when installing the new
seat. Failure to do so may cause the seat to loosen, resulting in loss
of control of the vehicle and causing serious bodily injury to the vehicle occupants and to others.
Track
Bar
Track
Insert M8-1.25x25 Bolts from
Parts Kit - Finger Tighten
Seat Cushion
(Front)
Lay the Bestop seat down with the
bottom of the seat facing up. Select
the hole pattern on the seat that
applies to your vehicle.
While the track slides are to the
rear of the seat, place the tracks
onto the Bestop seat. Install two
of the M8-1.25x25 Bolts from the
Parts Kit in the front track mounting
holes. Finger tighten the bolts.
Install the tracks on the
Bestop Seat
Insert M8-1.25x25 Bolts
from Parts Kit - Tighten to
21 Ft/Lbs
Track Bar - Push
down to slide
Track forward
Seat Cushion
(Front)
Track
Press down on the track bar and slide
the tracks forward. Install two of the
M8-1.25x25 Bolts from the Parts Kit in
the rear track mounting holes. Tighten
the rear bolts to 21 ft/lbs, using a
13mm Wrench.
Install the tracks on the
Bestop Seat
Failure to tighten the bolts and nuts to the specifi ed
torque can result in the seat loosening, thereby caus-
ing serious bodily injury to the vehicle occupants and to others.
Track
M8-1.25x25 Bolts -
Tighten to 21 Ft/Lbs
Seat Cushion
(Front)
Press down on the track
bar and slide the tracks
toward the rear of the
seat. Tighten the front
bolts to 21 ft/lbs, using
a 13mm Wrench.
Track Bar - Push
down to slide
Track to rear
Tighten the Front Bolts