Installation Manual

HighRock 4x4

Slider Step Installation Instructions

Rev. E 0910 49315 pg. 3

Assemble Tube Step

to Skid Plate

Hook Bungee Cord on Tube Step onto Skid Plate

and pull down onto Step Tube until Step Tube

Slides into Skid Plate.

Hook Cord to

Skid Plate

Slide Step Tube

into Skid Plate

Slide two (2) Skid Plate Glides into each end of Step

Tube.

Install Skid Plate Glides

Skid Plate

Step Tube

Glides

Secure Step Tubes to

Skid Plate

Slide Guide Sleeve through Step Tube and Skid

Plate Glides and secure with M8 x 80mm Hex

Head Cap Screw, two (2) M8 Washers and an M8

Nylon Insert Locknut. Repeat on both ends of the

Step Tube.

Guide

Sleeve

M8 x 80mm Hex

Head Cap Screw

M8 Washer

M8 Nylon Insert

Locknut

Preassemble Remaining

Slider Step

Repeat Steps 1 – 3 with the remaining Slider Step.

TJ Installation