Installation Manual

HighRock 4x4
TM
Slider Step Installation Instructions
Rev. E 0910 49315 pg. 4
Install Rivet Nuts
Use a 14mm socket and adjustable wrench to install
Rivet Nuts into the following holes.
Slide the Washer over the Rivet Nut Insertion As-
sembly Bolt and follow it with the Rivet Nut Insertion
Assembly Nut and a Rivet Nut.
Place the Rivet Nut Insertion Assembly into one of
the holes in the frame.
Use an adjustable wrench and a 14mm socket to
hold the Assembly square and fl ush with the hole.
Make sure the Rivet Nut sits fl ush with the frame
and tighten the bolt to 30 ft.lbs. Remove the bolt,
nut and washer.
Repeat this procedure for all following holes on both
sides of the vehicle.
Install Clip-On Nuts
Slide M6 Clip-On Nuts onto the six (6) tabs under
the body.
M6 Clip-On
Nuts
Install Mounting Bracket
Place the Mounting Bracket against the vehicle.
Start with the middle hole and install six (6) M6 x
25mm Socket Head Screws into the Clip-On Nuts.
Rivet Nut
Insertion
Assembly Bolt
Washer
Rivet
Nut
Rivet Nut Insertion
Assembly Nut
Rivet
Nuts
Rivet
Nuts
Install Front and Rear
Hanger Brackets
Check the hole and Rivet Nut alignment with Front and
Rear Hanger Brackets and select the correct brackets
for your vehicle. Use M8 x 25mm Hex Head Screws
and M8 Flat Washers to mount the Front and Rear
Hanger Brackets to the Rivet Nuts.
Front Hanger
Bracket
Rear Hanger
Bracket
M8 x 25mm Hex Head Screws
and M8 Flat Washers
M6 Clip-
On Nut
Mounting Bracket
M6 x 25mm
Socket Head
Screws
M6 x 25mm
Socket Head
Screw