Installation Manual

HighRock 4x4
TM
Slider Step Installation Instructions
Rev. E 0910 49315 pg. 5
Install Step Tube Assembly
Use four (4) M8 x 25mm Button Head Socket
Screws to mount the Skid Plate to the Mounting
Bracket. Do not tighten the bolts at this time.
Install Plastic Plugs
Install Plastic Plugs in the remaining holes.
Skid Plate
M8 x 25mm Button
Head Socket Screws
Secure Step Tube Assembly
Use two (2) M10 x 25mm Button Head Socket
Screws and M10 Flat Washers to mount the Step
Tube Assembly to the Front and Rear Hanger
Brackets. Do not tighten the bolts at this time.
M10 x 25mm Button Head Socket
Screws and M10 Flat Washers
Front
Hanger
Bracket
Rear Hanger
Bracket
Secure Tube Step Assembly
Once all screws have been started, tighten the M8 x
25mm Button Head Socket Screws from Step 9 and
the M10 x 25mm Button Head Socket Screws from
Step 10.
Plastic Plug