Installation Manual

TrekStep™ – Installation Instructions
Rev. C 0810 75301 pg. 3
Assemble the Mounting Bracket to the Linkage.
2500 & 3500 HD Vehicles:
Use the M10-1.5 x 35
Socket Cap Screws. Do not
use the Spacer.
Other Vehicles:
Use M10-1.5 x 80 Socket
Cap Partial Thread Screws
and the Spacer.
Assemble Linkage to
Mounting Bracket
Use the M6-1.0 x 20 Socket Head Cap Screws to
mount the Step to the Linkage Assembly.
Install Step
Slide the holes in the Mounting Bracket over
the studs on the vehicle. Reinstall the fasteners
removed in Step 2.
Install Linkage Assembly
Adjust the Step from side to side. Make sure to leave
clearance for foot access to lower step. Tighten the
allen head bolts.
Adjust Step
Linkage
Spacer
Mounting
Bracket
Large Socket
Head Screws
Allow foot access
to lower step
M6-1.0 x 20 Socket
Head Cap Screws
Operation
• The TrekStep™ is foot operated and deploys and retracts with a nudge of your foot.
• To deploy, press down using your left foot, on the forward outside corner of the step pad.
• To retract, gently kick the underside of the step pad.
• Max Load Capacity: 300 lbs.
• Always use appropriate hand holds when stepping up to or down from your truck’s cargo bed.
Maintenance Tips
The step pad surface and linkage arms can be washed with mild soap and water using a soft brush or
sponge to dislodge any mud, dirt or accumulated road grime. Rinse with fresh water.
To prevent slipping, avoid applying waxes, lubricants or protectants like Armor All® to the step surface.
Attention!
TrekStep™ SHOULD ALWAYS BE STOWED IN THE RETRACTED POSITION WHEN DRIVING.