Installation Manual

Rev. A 1298

Step Three

Open up the Sport Bar Cover so that the inside (white) of the cover is facing up. Lay the long (60") piece of foam, with the tape side down,

on the top part of the fabric assembly. Make sure that the foam is centered on the fabric. Lift the foam up enough to remove the protective

strip from the adhesive and press the foam firmly into place on the fabric. The adhesive is intended to assist in the installation of the pad

and may not form a permanent bond.

Step Four

Lay the medium (36") pieces of foam, with the tape side down, on each of the longer rear legs of the fabric assembly. Make sure that the

foam is centered on the fabric. Lift the foam up enough to remove the protective strip from the adhesive and press the foam firmly into place

on the fabric.

Installation

Step One

If a top is on the vehicle, it must be removed before starting this installation.

Step Two

On a flat, clean surface, spread out the fabric assembly. The long part will go along the top of the sport bar, the four legs will go on the angled

rear legs and the short front legs (see Figure 1).

Figure 1

Sport Bar Fabric Assembly -

Vinyl down

Rear Leg

Front Leg

Top

Zippers

Sport Bar

Rear Leg

Front Leg

Sport Bar Cover Installation Instructions

Model: Wrangler 1986 - 1990

Part Number: 80008

Note: Please read these instructions thoroughly before beginning the installation. After completing the installation, keep

this manual for future reference.

Parts List

Fabric Assembly 1 ea.

Fabric Covered Foam Tubes 2 ea.

Foam, 60" x 1/2" x 9" (long) 1 ea.

Foam, 36" x 1/2" x 9" (med.) 2 ea.

Foam, 23 1/2" x 1/2" x 9" (short) 2 ea.

Warning:

This product is designed to enhance the appearance of the vehicle and to shield the occupants from ordinary weather conditions.

Do not rely in any way on the components of this product to contain occupants within the vehicle, or to protect against injury or

death in the event of an accident. This product will not protect the occupants from falling objects. Never operate vehicle in excess

of manufacturer's specifications.

Wear seat belts at all times.

Read and follow, precisely, all installation instructions provided when installing this product. Failure to do so may result in a poor

fit and could place occupants of the vehicle in a potentially dangerous situation.

PAGE 1
Sport Bar Cover Installation Instructions Part Number: 80008 Model: Wrangler 1986 - 1990 Note: Please read these instructions thoroughly before beginning the installation. After completing the installation, keep this manual for future reference. Parts List Fabric Assembly Fabric Covered Foam Tubes Foam, 60" x 1/2" x 9" (long) Foam, 36" x 1/2" x 9" (med.) Foam, 23 1/2" x 1/2" x 9" (short) 1 ea. 2 ea. 1 ea. 2 ea. 2 ea.
PAGE 2
Step Five Lay the short (23 1/2") pieces of foam, with the tape side down, on each of the short front legs of the fabric assembly. Make sure that the foam is centered on the fabric. Align the slit in the foam with the bolt cut out in the fabric. Make sure that the right and left foam pieces are on the proper sides (see Figure 2). Lift the foam up enough to remove the protective strip from the adhesive and press the foam firmly into place on the fabric.
PAGE 3
Step Ten Close the zipper on the front legs, from top to bottom. Make sure that the fabric tab lays flat under the zipper. Step Eleven Place a fabric covered foam tube onto each of the horizontal bars so that it zips from front to back Position the fabric with the zipper underneath the bar. Close the zipper and tuck the end of the inside the tube.