Installation Manual

Trail Cover – Installation Instructions

Rev. D 0707 81037 pg. 2

Parts List

Trail Cover Fabric Qty - 1

Stuff Sack Qty - 1

Orient the Trail Cover with the Bestop label on the

driver's side. Drape the Trail Cover over the vehicle.

Place Trail Cover on Vehicle

Secure Elastic Straps

There are two plastic strips sewn to each side of

the Trail Cover. Slip them into the belt rail retainer

on the side of the vehicle.

Secure Plastic Strips –

Soft Top Vehicles Only

If you have a Duster installed on your

vehicle, use only the elastic straps and

to hold the Trail Cover in place.

NOTE

• Make certain that the vehicle engine and all

lights are turned off.

• Set the Emergency (Parking) Brake.

• Remove all personal possessions from the

vehicle.

Preparing the Vehicle

Hook Straps to

Bottom of Vehicle

Hook Loops

around Hinges

Pull down gently

and slip plastic into

retainer

Locate the two adjustable straps sewn on each side of

the Trail Cover. Pull the straps down and hook them to

the bottom of the vehicle.

Make sure that the fabric ﬂ ap inside the cover lays ﬂ at

behind the lower grommet.

Pull the end of each strap to tighten the

straps so that the cover ﬁ ts snugly on

the vehicle.

Hook the elastic loops on the front of the

cover around the windshield hinges.

Pull Strap to

adjust Straps