Installation Manual

90024 pg 2
1004 Rev. A
Installation
Duster Qty - 1
Parts List and Hardware Identification
#8 x 1/2" Pan Head Washer Screw -
Black, Qty - 4, Part Number 200.48
Tailgate Retainer Mount, Left,
Qty - 1, Part Number 311.85
Tailgate Retainer Mount, Right,
Qty - 1, Part Number 311.86
Tailgate Bar, Qty - 1,
Part Number 288.75
Tools Needed
#2 Phillips Screwdriver
Power Drill*
1/8" Drill Bit*
* on some models
Safety glasses should be worn at all
times while installing this product.
Step One
INSTALL TAILGATE RETAINER MOUNTS
Locate the left and right Tailgate Retainer Mounts. Place the mounts flush with the edge of the
tailgate opening. Install the Tailgate Retainer Mounts with two #8 x 1/2" Pan Head Washer
Screws for each mount.
If your vehicle does not have holes at this location, align the Tailgate Retainer Mounts flush with
the edge of the tailgate opening. Then mark the locations of the holes in the mounts, center
punch and drill a 1/8" hole at the marked locations. Install the mounts with two #8 x 1/2" Pan
Head Washer Screws for each mount.
Tailgate Retainer
Mount (Left)
Tailgate
Opening
#8 x 1/2" Pan Head
Washer Screws
Place Tailgate
Mount flush with
edge of opening
Web Buckle Strap, Qty - 1,
Part Number 312.01
Center Punch*
Safety Glasses
Caution