user manual

80019 1

Rev. A 1298

Sport Bar Hoop Installation Instructions

Model: Wrangler 1992-1995 Part Number: 80019

Note: Please read these instructions thoroughly before beginning the installation. After completing the installation, keep this

manual for future reference.

Parts List

1 - Cover Assembly

3 - Foam Pieces

Sport Bar Hoop Installation

Step One

If a top is on the vehicle, it must be removed before starting this installation. It will be easier to install the Sport Bar Hoop if the

hardware and bows are down. Slide the rear bow forward. Unlock the hardware attachment at the windshield and pull the

horizontal bar off the pins. Bend the spreader rods and slide the bows forward. Fold the whole assembly back onto the rear

of the vehicle.

Step Two

Place the fabric and foam assembly over the sport bar and align the holes in the front of the fabric assembly with the

Horizontal Support Bars. The zippers should be located on the underside of the sport bar. Start the 11" zippers on the front

shoulder 1-2 inches to hold the cover in place.

Step Two

Determine the right and left leg foam. Line up the slit and the cutout in the foam with the seat belt cutout tab, and cutout in

the fabric. Remove the protective strip from the back of the foam and press the adhesive strip on the foam to the fabric.

Foam Installation

Step One

On a flat, clean surface, spread out the fabric assembly. Lay the 36" center foam piece on backing side of sport bar cover.

The foam piece runs from one end of the zipper to the other. Remove the protective strip from the back of the foam and

press the adhesive strip on the foam to the fabric.

Figure 1

Front

Rear

Leg

Line up slit and cut out

Center foam

piece - from end

to end of zipper

Foam

Fabric

Warning:

This product is designed to enhance the appearance of the vehicle and to shield the occupants from ordinary weather conditions.

Do not rely in any way on the components of this product to contain occupants within the vehicle, or to protect against injury or

death in the event of an accident. This product will not protect the occupants from falling objects. Never operate vehicle in excess

of manufacturer's specifications.

Wear seat belts at all times.

Read and follow, precisely, all installation instructions provided when installing this product. Failure to do so may result in a poor

fit and could place occupants of the vehicle in a potentially dangerous situation.

PAGE 1
Sport Bar Hoop Installation Instructions Part Number: 80019 Model: Wrangler 1992-1995 Note: Please read these instructions thoroughly before beginning the installation. After completing the installation, keep this manual for future reference. Parts List 1 - Cover Assembly 3 - Foam Pieces Warning: This product is designed to enhance the appearance of the vehicle and to shield the occupants from ordinary weather conditions.
PAGE 2
Figure 2 Loop Strip toward front of vehicle Zip center zipper Holes in front for Horizontal Support Bars Start shoulder zipper 1-2" Holes in legs align with seat belt assembly bolts Leg Step Three Zip the zipper across the center of the sport bar (see Figure 2). Step Five Close the zipper on the shoulder of the front leg. Attach the hook and loop and zip the bottom of the front leg closed.