user manual

ManualsBrandsBestop ManualsCar SeatCar Seat 39331

39331/39341 pg 1

1201 Rev. B

TrailMax™ Fold and Tumble

Rear Seat

Installation Instructions

Before you begin installing this seat, please read all installa-

tion instructions and warnings thoroughly.

This seat is designed to be used on the model vehicles

described above. Use of this seat on any other vehicle or

failure to install this seat properly may result in an improperly

mounted seat and could result in unexpected movement of

the seat and loss of control of the vehicle, thereby placing the

occupants of the vehicle and others in a potentially danger-

ous situation.

This seat system is intended to be used with seat belts at all

times. Do not rely on the seat to maintain the seating position

of occupants, in the event of an accident.

WEAR SEAT BELTS AT ALL TIMES

Read and follow, precisely, all installation instructions pro-

vided when installing this product. Failure to do so may result

in a poor fit and could place occupants of the vehicle in a

potentially dangerous situation.

WARNING

For: Jeep

Wranglers 1997 and Newer Part Number: 39331 Vinyl

39341 Cloth

Jeep

is a registered trademark of Chrysler and

Bestop is not affiliated with Chrysler Corporation.

Summary of content (5 pages)

PAGE 1
TrailMax™ Fold and Tumble Rear Seat Installation Instructions For: Jeep® Wranglers 1997 and Newer Jeep® is a registered trademark of Chrysler and Bestop is not affiliated with Chrysler Corporation. Part Number: 39331 Vinyl 39341 Cloth WARNING Before you begin installing this seat, please read all installation instructions and warnings thoroughly. This seat is designed to be used on the model vehicles described above.
PAGE 2
Parts List and Hardware Identification Tools Needed Seat, Qty - 1 8mm Flat Washer, Qty - 4 Adjustable Wrench or 1/2" Wrench 13mm Wrench Cotter Pin, Qty - 2 M8-1.25 x 35mm Bolt, Qty - 4 Floor Mounting Bracket, Lt., Qty - 1 Floor Mounting Bracket, Rt.,Qty - 1 5/16-18 x 1 1/4" Bolt, Qty - 4 Lock Down Bracket, Lt., Qty - 1 Lock Down Bracket, Rt.
PAGE 3
Seat Installation If your vehicle has carpet covering the floor, cut the carpet so that the Floor Mounting Brackets are installed flush on the metal floor. If the Floor Mounting Brackets are not flush mounted, the seatback may not lock in place, which could result in serious injury to you and others. WARNING Step One Floor Mounting Bracket Installation Floor Mounting Brackets Cutout toward front Locate the Floor Mounting Bracket mounting holes on the floor of the vehicle behind the front seat risers.
PAGE 4
WARNING Failure to install the Cotter Pin may result in the seat moving off the Front Brackets which could result in serious injury to you and others. Step Three Seat Legs Seat Seat Installation Slide Lower Rear Pin on Seat into top hole in Floor Mounting Brackets Orient the Seat, with the Legs on the bottom of the seat facing the rear of the vehicle. Fold the Seat back down into the closed position. Place Seat in the vehicle. Locate the two (2) pins in each front corner of the seat cushion.
PAGE 5
Care of your Bestop Seat Your seat is made of the finest materials available. To keep it looking new and for the maximum possible wear, it will need periodic cleaning. Washing: The seat fabric should be washed often using a mild detergent, warm water and a soft bristle brush. Rinse with clear water to remove all traces of soap. LIMITED WARRANTY We warrant our product to be free from defects in material and workmanship, for terms specified below, provided there has been normal use and proper maintenance.