Operation Manual

User’s instructions
27
English
4. Press the foot button on the nozzle to set the
combi nozzle for use on hard orsoft surfaces,
see Figure 3b. For use on hard surfaces, press
the foot button on the combi nozzle to extend
the brushes. Lift the button for use on soft
surfaces.
5. The power cord has a yellow and red mark, see
Figure 4A. Pull out the cord to the yellow mark.
Never pull out the power cord beyond the red
mark. This could damage the power cord.
6. Put the plug in the wall socket, and press the
On/Off switch. To switch off the appliance, press
the On/Off switch again, see Figure 4B.
7. The appliance is now ready for use. You can
move the vacuum cleaner while you are
cleaning by pulling on the hose grip. You can
lift the appliance with the vacuum cleaner’s
handle.
Note If so required, you can reduce the suction
quickly by moving the slide on the hose
grip.
ACCESSOIRIES
This vacuum cleaner is supplied with one combined
accessory:
• a crevice tool with a narrow nozzle, which
you can use to clean radiators, window
frames, crevices, small openings, and
similar;
• a dusting brush, which you can use to clean
delicate or irregular surfaces, furniture,
Venetian blinds, and similar.
OPERATION - Storage after use
1. Remove the plug from the wall socket.
2. Press the rewind button and keep it pressed in; the power cord will automatically rewind onto the reel.
Guide the power cord whilst it rewinds onto the
reel, since otherwise the cord could become
tangled or the plug could strike the back of the
appliance. Take hold of the power cord near the
mark, and allow it to gently slide through your
fingers back into the appliance, see Figure 6
3. Slide the bottom of the combi-brush bracket
into the slot. This avoids the need to dismantle
the vacuum cleaner after use; you can store
the assembled appliance and retrieve it again
quickly when you need it.
3a
3b
3c
3d