E-bike User’s Manual CAUTION READ THIS MANUAL BEFORE USING YOUR EQUIPMENT
CONTANTS Safety instruction------------------------------------------------------------------Page 1 Instruction-------------------------------------------------------------------------Page 1 Meter operation-------------------------------------------------------------------Page 2 Battery:Further information and maintenance-----------------------------------Page 3 Charging---------------------------------------------------------------------------Page 3 Installation Instruction--------------------------------
1. Safety Instruction ___________________ 1. Thank you for purchasing the ANCHEER E-BIKE. The E-BIKE features the most recent innovation in technology. 2. For Safety reasons, it is most important that you read this user’s manual before you operate the bike. Improper handling can reduce its riding performance and most importantly, cause danger to your safe and healthy. 3.
3. Meter operation 3.1 Meter instruction 3.2 Meter operation Operating instructions To switch on/off the E-Bike system, hold the button for 2s. The default value is “low” pedal assist level. Press “+” to crease into pedal assist level “Mid”. Press “+” again to move into pedal assist level “High”. “High” is the maximum power of PAS. Full Electric Function (Pure electric mode): Press”-“, until all the three “low””Mid””Hi gh” indicators are off. 3.3 Operation Cautions Be careful of the safety use.
4. Battery: further information and maintenance 1. How far full charge battery can go? That depends on the loading weight, road condition and battery capacity. But in the same condition, average speeds can continuous longer travel range. 2. When storing the battery for a longer time period, (e.g. during winter time) it is important to place the fully charged battery on a flat surface in a dry place. 3.Attention: The battery should be re-charged once every 2-3 month when it is not used. 4.Warning: 4.1.
. Installation Instruction 1.Installation video please refer to: https://drive.google.com/file/d/0B8ArYrneLylHeHhVZzUzU1pUUXM/view ( Could ask our customer service for the video). 2. When open the bike's carton box, take out E-bike and use tools to cut off the package strings. 3. Install the handlebar: 3.1 use inner hexagon tool to loosen the stem cover and don't tighten all bolts immediately before adjusting the handlebar in a property angel and position, 3.2 then tighten with tool. 3.1 3.2 4.
4.3 4.3 4.4 5.Install the front light 5.1 Take the screw from the fork; 5.2 Open the lamp 5.3 Install the lamp and used the tool to tighten it. 6 .Install pedals: Check 2 pedals, the one imprinted "L" should install in left side and "R" in right side. Please use wrench to tighten them.
7. Install the Seat post. 7.1. Open the seat post and saddle, then install the rear reflector; 7.2 Put the seat post into the frame. 7.3 Adjust seat post to the height that suits your riding position best and tighten quick release. ( Please make sure that the quick release is tightened firmly.) 7.1 7.2 7.3 7.3 8. Adjust angle of brake lever, meter,gear shifter,throttle and louder controller on handle bar, then tighten them with tools. 9. Install battery 9.1 Open the box of battery 9.
Detail Model Packing List Descripation Quantity Bike Tool (open-end spanner13-15, 1 open-end spanner14-17,screwdriver,inner hexagon 1 spanner M6,M5,M4) AM001907 Manual 1 Key 2 Charger 1 Battery 1 Pedal 1 Reflactor 1 (底面空白)