Use and Care Manual

1. Now the sand filter is ready for use. Set

the Control Valve to the Filter function.

NOTE: To prevent the risk of electrical shock

dry any excess water from yourself and the sand

filter.

IMPORTANT: Before operation, make

sure the tank is placed steadily on its base and connected correctly to the

pump.

2. Switch on the sand filter to run it.

NOTE: The sand filter has now started its filtering cycle. Check that

water is returning to the pool and take note of the filter pressure on

Pressure Gauge. Generally, the recommended sand filter pressure is

less than 0.56 Bar (8.0 PSI) when it is running.

CAUTION: You must ensure the sand

filter is switched off and unplugged before any

maintenance begins or severe risk of injury or

death exists. As dirt builds up in the sand

filter, the pressure reading on Pressure

Gauge will increase. When the Pressure

Gauge is 0.56 Bar (8.0 PSI) or higher, or

water flow to the pool is too low, it is time to clean the sand. To clean the

sand bed, follow all instructions outlined previously in : Backwash and

Rinsing.

NOTE:

1. The Pressure Gauge is just used for measuring the water

pressure, not used for precision measurement.

2. We recommend you clean the sand bed once a month or

less regularly depending on how often the pool is used.

Do not clean the sand too frequently.

SAND FILTER MAINTENANCE

1.6

1.4

1.2

0.8

0.6

0.4

0.2

psi

bar