Specifications

2
14
DISASSEMBLING THE ENGINE
Disassembling the intake manifold and lamella pack.
EXPLODED VIEW OF THE INTAKE CONTAINER.
A) screws;
B) intake container;
C) lamella pack;
D) seal.
INTAKE SYSTEM
The intake system consists of the intake ma-
nifold B and the lamella pack C. To disas-
semble this, remove the four screws A that
fasten the intake manifold and the lamella
pack to the casings. Decouple the intake
manifold and seal D from the lamella pack.
2.2
A
B
A
D
C
Complete ignition system.
B
D
C
A
F
E
IGNITION SYSTEM
The ignition system consists of the flywheel
A, the stator windings B (stator for short)
and the magnetic pick-up C. The complete
stator is fastened to the support D with two
screws and the support is fastened to the
right casing with three screws. The flywheel
is fastened to the motor shaft by the spe-
cial nut E. The safety washer F is interposed
between the flywheel and nut. Proceed as
follows to disassemble the parts.
2.3