Specifications

3
25
ASSEMBLING AND TESTING THE ENGINE
MOUNTING THE COMPLETE
MOTOR SHAFT
The complete motor shaft is first coupled with
the left casing. To do so, you must heat the
main bearing and the area around it. Conti-
nue heating until the motor shaft is inserted
into the bearing with minimal hindrance.
Before starting the heating process it is re-
commended to grease the oil seal found on
the outer side of the casing.
GEARBOX UNIT: TESTING AND
REASSEMBLING
As seen in paragraph 1.7, the gearbox unit
consists of the control and the gearbox itself.
The control is in turn split into internal and
external controls.
Hereunder are the tests and reassembly pro-
cedures of such units to the engine.
TESTING THE TOOTHED WHE-
ELS AND SHAFTS
Perform the following inspections on all to-
othed wheels:
• verify the wear-and-tear of the sliding sur-
faces;
• verify there are no cracks and abnormal
wear-and-tear on the sides of the teeth
A;
• verify that the engagement parts B of
the toothed wheels are not chipped or
rounded;
• verify that the areas C that make contact
with the forks are not particularly worn.
Moreover, verify that the shafts supporting
the toothed wheels do not present any si-
gns of seizing or wear-and-tear.
3.2
3.3
3.3.1
Verifications to be performed on the toothed wheels
Heating the bearing.
Attention!
Be careful not to deteriorate the oil seal during
heating.