Specifications

3
34
ASSEMBLING AND TESTING THE ENGINE
3.7
PRIMARY GEAR AND CLUTCH
UNIT
After having verified that the teeth of the
primary gear do not have any dents and/or
abnormal wear-and-tear, insert the primary
gear into the conical part of the motor shaft
(left side) straight after having thoroughly
degreased the part of the shaft in question
and the opening on the gear. Then insert
the fastening screw as far as possible.
The fastening screw between the motor shaft
and the primary gear must have a torque of
120Nm. This can be implemented once the
clutch bell is inserted by using the special
primary tool A (code 007.14.000.0.0).
A