Specifications

3
39
ASSEMBLING AND TESTING THE ENGINE
3.8
Once this is tightened well, fold the two
flaps on the safety washer for them to rest
onto the nut.
Grease the clutch discs with new transmis-
sion oil and insert the clutch discs set, alter-
nating a driving disc and a driven disc.
Enter the longer part of the thrust plate 10
into the housing on the primary shaft and
the thrust bearing 11 together with the spe-
cial washer 12.
Close the clutch bell with the pressure plate
cap 13, insert the springs into the respecti-
ve housing on the cap and then the washers
15 6x18 and the screws 16 M6x16 that must
be tightened to 10Nm in a cross-wise pat-
tern, whilst keeping the clutch assembly
blocked in place by means of the special
primary tool (code 007.14.000.0.0).
Tightening order of the clutch bell bolts.
6
4
2
5
3
1
3.8