Specifications

3
41
ASSEMBLING AND TESTING THE ENGINE
3.10
3.10.1
3.10.2
IGNITION SYSTEM
Before reassembling the ignition system,
you should carry out the following inspec-
tion.
TESTING THE IGNITION STATOR
The stator winding must be inspected while
the temperature of the component is ap-
proximately 20 °C.
The inspection may also be performed with
the generator coupled to the engine.
Disconnect the 12-way black connector
between the generator and CDI and with
the use of a multimeter, verify that the resi-
stances read between the terminals shown
below fall within the prescribed range:
black-white (pick-up): 320 ohm ± 15%
red-blue (condenser): 300 ohm ±15 %
yellow-brown (services): 0.45 ohm ±20 %
STATOR AND PICK-UP WINDING
Insert the stator winding and pick-up into
the respective housing whilst being careful
not to crush the cables between the stator
and pick-up.
Apply medium resistant thread stoppers to
bolts A and B and then tighten both bolts A
to a torque of 8Nm and the three bolts B to
a torque of 6Nm.
Verifying stator winding functionality.
Stator 1 and pick-up 2 assembly.
B
A
B
A
B