Specifications

3
42
ASSEMBLING AND TESTING THE ENGINE
FLYWHEEL
After having thoroughly degreased the coni-
cal surfaces, insert the flywheel into its com-
partment on the right side of the engine,
ensuring that the opening on the flywheel
enters the Woodruff key. Insert the special
washer and the nut that fastens the flywhe-
el to the motor shaft.
Keep the flywheel in place with the use of
a special universal device A and tighten the
nut that blocks the flywheel onto the motor
shaft at a torque of 140Nm.
The GB version is provided with an extra
mass. This must be applied to the flywhe-
el once again and fixed by the two specific
screws which must be tightened at a torque
of 20Nm.
3.10.3
Mounting the flywheel onto the motor shaft.
A