Specifications

4
54
MOUNTING THE ENGINE ON THE VEHICLE AND REPOSITIONING THE COMPONENTS
COUPLING THE CLUTCH
ACTUATOR, PINION AND
FLYWHEEL CASING
Place the clutch actuator in its housing and
tighten the four bolts (M5x12) with a torque
of 6Nm.
Proceed as follows to insert the pinion onto
the output shaft.
Ensure that the chain is channelled into the
guide found on the protection block A on the
swing arm. Insert the pinion into the chain
and whilst turning the tensioner B down-
wards, insert the pinion onto the output
shaft until it reaches the Seeger mounted
onto the shaft. Insert the external Seeger.
Let the tensioner go and whilst turning the
wheel ensure that no blockage occurs.
Then couple the flywheel casing with the
engine by means of the three bolts M6x20
that are to be tightened with a torque of
10Nm.
Rotating the chain tensioner
Inserting the pinion into the output shaft.
4.3
B
A
The three screws of the flywheel casing.