Specifications

1
6
REMOVING THE ENGINE FROM THE VEHICLE
Liquid drain plug.
The screw that fastens the coil support to
the radiator.
Connectors A, B and C.
The screws that fasten the left side to the tank.
WATER COOLING RADIATOR
Before removing the water radiator you
should empty the cooling system by remo-
ving the drain screw found on the pump
body. Open the radiator cap and slightly tilt
the vehicle to the left to facilitate the liquid
flow.
It is recommended to perform this operation
after having removed the protection plate
so as to prevent the coolant from remaining
on the plate.
The liquid can be reused if it has a clear
blue colour.
Loosen the screw that fastens the coil sup-
port to the radiator. Once this is implemen-
ted, the coil and its support will be fastened
to the vehicle solely by the high and low
voltage cables.
In order to prevent the cables from being
stretched, it is recommended to disconnect
the pipette -high voltage cable- from the
spark plug and fasten the frame with clam-
ps.
You must disconnect the thermal bulb and
the fan from the electrical system in order to
remove the radiator. Loosen the two screws
that fasten the left side to the tank in order
to access the relative connectors. Then di-
sconnect connectors A and B, respectively,
from the electric fan and the thermal bulb.
To loosen the left side from the vehicle com-
pletely, simply disconnect connector C that
connects the map switch to the electronic
control box.
1.4
A
C
B