Specifications

6 - Motor Release 01 Date 09/2007

Fitting the flywheel

– Unscrew the crankshaft fixing screw, fit seal ring 1 and tighten

the crankshaft fixing screw to 25 N·m (see above).

– Ensure that the key is properly seated in the crankshaft and

then fit the flywheel on the crankshaft.

– Fit the wave washer and the flange nut. Pushing with the

clutch retainer, tighten the flange nut to 60 N·m.

Fitting the pick-up and the ignition cover

– Position the pick-up in the crankcase and insert cable guide 2

in the specially designed opening in the crankcase.

– Degrease the thread of the two screws 3 (M5x16), apply Loc-

tite 243 and tighten the screws to 6 N·m.

– Fit a new gasket and fasten the ignition cover with the four

screws (4 and 5). Tightening torque: 10 N·m.

NOTE: Fit the two longer screws 4 (M6x35) in the holes with the

centring bushes.

66_Inghilterra_059311 27-12-2007 18:32 Pagina 67