User`s manual

11
MACHINE PREPARATION
15. ADJUSTING THE SQUEEGEE HEIGHT
The height of the squeegee must be adjusted based on wear of the squeegee
blade. To do this, turn the knobs (2) counter clockwise to raise the squeegee,
and clockwise to lower it.
Note: the right and left wheels must be adjusted to the same level, so the
squeegee works parallel to the floor.
16. ADJUSTING THE SQUEEGEE INCLINATION
During working operation, the rear squeegee blade is slightly bent backwards
(by about 0.2 in (5 mm)) in a uniform manner for its entire length. If it is neces-
sary to increase the bend of the squeegee blade in the central region, you must
tilt the squeegee backwards, rotating the adjuster (1) counter clockwise. To
increase the bend of the squeegee blade at the sides of the squeegee, rotate the
adjuster clockwise. When fully adjusted, tighten the jam nut.
17. RECOVERY TANK
Check the drain hose cap (on the rear of the machine) to ensure it’s closed.